![]() ![]() ![]() I just run scans to get the network topology. That being said, I'm open to suggestions.Ä®dit: I don't actually connect to the wifi using my phone at any point. Now, use airodump to confirm the available wireless networks, as given in the following command: Command: airodump-ng wlan0mon As you can see, the third networkâs ESSID is identified only as .I'm hoping I can use signal strength to filter them out. Command: airmon-ng start wlan0 If you reconfirm with ifconfig, you will see that there is now a monitoring or wlan0mon address in use. In Autogamic I can get the signal strength of the strongest BSSID, but I've checked and it's not always the same one even when I'm stationary in the lab.įinally, I've tried just looking to see if the lab BSSIDs are available, but they do reach outside the lab. Start Airodump-ng to dump the packets from Wireless Monitor airodump-ng mon0 where mon0 is the monitor initiated on the interface wlan0. I think I should be able to look at the signal strength of one or two specific access points to know if I'm in the lab. Type iwconfig at terminal to get the wireless interface name of wireless device on your machine. My company has dozens of access points with the same SSID. My goal is to make my phone change volume levels based on my location within the building. I would like to be able to get the wifi signal strength for one specific BSSID even though several BSSIDs are available with the same SSID.Īt work I spend about half my time in a quiet cubicle environment, and the other half in a noisy lab. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |